Overview

Issue After the KATA/Sensor receives traffic, no traffic information is visible on the KATA Dashboard. Cause If the traffic is less than 1 mbps, it will not be shown on the graphs Solution Check by the following. Log in to CN/Sensor's ssh console Execute the command sudo -i iptraf-ng Select General interface statistics, you can see the real-time traffic information of the network interface However, such low traffic is NOT normal, and if there is no reasonably high traffic on span network interfaces on sensors, check your network configuration.

KESMac 12 integration with KATA is ONLY supported in KATA 6.0 and newer. Attempt to connect KESMac 12 to lower versions of KATA will result in processing errors and display issue, as if all agents are inactive. The issue will persist until all KESMac agents are disconnected from the node of the lower version.