Jump to content

About this blog

Entries in this blog

How to send file to KATA via API [KATA/KEDRE]

This article provides additional details to the Online Help article. Modern web servers use gzip compression for transferred web pages. Such compressed web pages should not be sent to KATA API as these files will create unnecessary load on Sandbox. Content-Type - Optional parameter objectType - must always be a file (other types are not supported) content - object to send scanId - ID of the object sent to KATA (must be unique) sensorId - ID of the system sending

svc_kms

svc_kms in How-to

No traffic on Dashboard Due to low traffic [Kaspersky Anti Targeted Attack]

Issue After the KATA/Sensor receives traffic, no traffic information is visible on the KATA Dashboard. Cause If the traffic is less than 1 mbps, it will not be shown on the graphs Solution Check by the following. Log in to CN/Sensor's ssh console Execute the command sudo -i iptraf-ng   Select General interface statistics, you can see the real-time traffic information of the network interface However, such low traffic is NOT normal, and if there is no rea

Stan Shpatar

Stan Shpatar in Known Problem

Processing and display issues after adding KESMac [KATA/KEDRE]

KESMac 12 integration with KATA is ONLY supported in KATA 6.0 and newer. Attempt to connect KESMac 12 to lower versions of KATA will result in processing errors and display issue, as if all agents are inactive. The issue will persist until all KESMac agents are disconnected from the node of the lower version.

Stan Shpatar

Stan Shpatar in Info



×
×
  • Create New...