tommylwl

This issue has been sloved in KES 12.3.0

2 more points. 1. You must have "Endpoint Security for Business Advanced" licnese if you are using Windows Server, otherwise, it won't work for the Application Control. https://support.kaspersky.com/KESWin/12.3/en-US/228553.htm 2. I use a windows 10 vm and try to get the list of the running processes. Those processes are successfully listed in the Security Center, and I can block the process in this windows 10 (refer to Arian.Mohammad screen capture). As those serves and this windows 10 are in the same managed device group, I tried those servers but if faill. The process in those servers are not blocked. These is what i figure out these few days. The license issue waste me 4 hours. = ='

Thank you very much. I mess up "General" and "General Settings". And don't know need to turn on the "Application Control" to collect the list of startup application.

I want to limit a process, abc.exe, for outgoing traffic. Therefore, I open my policy in the KSC, Under Essential Threat Protection, Firewall. In the right pane, Click "settings" of configure applicaiton network rules in the operation system. When I select untrusted, and then "Add", the applicatioin list is empty. Then, I try at the Host Instruction Prevention, there has a message "To send application startup information to Administration Server, select 'Reports and Stroage'.......". I try to follow the instruction, but there is no such option. May I know a correct way to limit the abc.exe outgoing traffic?

It is fresh install. All the below scenarios have Remote desktop IP Virtualization on. Windows 2016 + KES 12.2.0 = ok Windows 2022 + KES 12.1.0 = ok Windows 2022 + KES 12.2.0 = Connection blocked

I have a server farms for users to remote. It is windows 2016 with IP virtualization + End Point Security 11.10, everything works fine. But today, I had clean install 2 servers with server 2022, config with IP virtualization and also upgrade to End point security 12.2, when i open the brwoser in remote desktop, all the internet connection fail (see attachment) . If i disable the End Point Security Service, it is normal. I have tried to allow all outgoing connection in the firewall rule, but no use. How to fix this issue? Any idea?