GZKCY

Virus als.pasdoc.a

7 posts in this topic

6 Months ago kaspersky found als.pasdoc.a virus in my system. but kaspersky can only remove the acaddoc.lsp file created by virus while using autocad program. when scan and remove the found viruses and open autocad again it directly forms the lsp file again. is there a way to remove this virus completely from the system. i have attached the avz.log file.

 

if needed i can give the lsp file formed by virus.

 

thanks for help.

sysinfo.zip

Share this post


Link to post
Share on other sites

till november i still have not got any response from kaspersky lab. any one who knows how i can get rid of this thing can help me.

thanks

Share this post


Link to post
Share on other sites

Does this happen also with new autocad sessions or only when you open an old one?

 

Untick the box in AutoCAD's settings "load acad.lsp with every drawing". Does it help?

Screenshot here - http://docs.autodesk.com/ACD/2010/ENU/Auto...umber=d0e282661

 

 

Also, in your MyComputer scan settings, if its not selected, set it to scan "All files" rather than only "by format"

Edited by dawgg

Share this post


Link to post
Share on other sites
Does this happen also with new autocad sessions or only when you open an old one?

 

Untick the box in AutoCAD's settings "load acad.lsp with every drawing". Does it help?

Screenshot here - http://docs.autodesk.com/ACD/2010/ENU/Auto...umber=d0e282661

Also, in your MyComputer scan settings, if its not selected, set it to scan "All files" rather than only "by format"

 

the settings are as what you told. but no effect. and the virus does not form if you make a new drawing from start. but after you save it and open it acaddoc.lsp file can be seen. thanks for your help.

Share this post


Link to post
Share on other sites

Did you run a scan which was set to scan "All files"? In the scan, untick "scan new and changed files only" and untick "iSwift" and "iChecker" in the "Additional" tab.

 

If that did not help, try contacting the autodesk forum if they have any solutions - http://discussion.autodesk.com/forums/

Edited by dawgg

Share this post


Link to post
Share on other sites
Guest
This topic is now closed to further replies.